Descaler Powder NI

Product description

Applications

DESCALER POWDER NI is suitable for removing water scale and rust in diesel engine cooling water systems, boilers, evaporators, condensers, etc.

Directions for use

Descaling can be accomplished by circulation, for large components and systems, by in-situ soaking, or by soaking in an immersion bath for small components. The most effective method is by circulation as it ensures renewal of acid film in contact with the scale.

CIRCULATION METHOD
If the deposits to be removed are covered with oil or grease, a degreasing treatment with a solution of 2 – 8% TANKCLEAN ALKALINE, CARBON REMOVER NC or SEACLEAN VOYAGE with water should be carried out prior to descaling. Circulate the solution for 4 – 6 hours. To accelerate the cleaning process the solution should be heated up to a temperature of 60°C.

After degreasing, a descaling treatment with a solution of 5 – 10% by weight of DESCALER POWDER NI mixed with water should be circulated. The cleaning time depends on the nature and state of deposits. To avoid saturating the solution, do not exceed solution strength of 10%. Ensure circuit is vented at the highest point to release gases produced during descaling operations.

Product solution may be heated to increase the descaling process rate up to a maximum of 60°C. Regenerate the solution by adding more DESCALER POWDER NI. To avoid the possibility of a saturated solution, no more than 2 regenerations should be made. If further treatment is necessary the circuit should be drained and a fresh charge introduced.

A check on the progress of the descaling operation may be made by placing scale samples in easily observed positions. When the samples are completely dissolved, circulate for one more hour, then drain system thoroughly. Rinse thoroughly with water then drain until pH 7 is reached. Neutralise the acidic effluent drained from the descaling solution by using ALKALINITY CONTROL until an acceptable pH value is obtained.

SOAKING METHOD
Procedure is similar to that for circulation, i.e. degreasing, descaling (ensure ventilation!), rinsing and neutralising. The same solution strengths should be used. If agitation of the descaling is carried out the cleaning process will be accelerated.